TNL Robotics / Technical note / R0 · 19 October 2026

AI footwear inspection with a robotic arm

Design and simulation values; not validated on hardware. This sheet supports pilot discussions. It is not a performance guarantee, safety certification or manufacturing release.

ParameterR0 design
Light booth466 × 466 × 640 mm internal; 300 × 300 mm opening; 290 mm travel.
Door movementOpen ≈ 0.52 s / lower ≈ 0.71 s, simulation. Not inspection cycle time.
Shoe sizeUp to EU 48 by design: 340 × 130 × 120 mm.
Top cameraf = 12 mm; WD 434 mm; FOV 511 × 374 mm; 0.125 mm/px.
Side cameraf = 6 mm; WD 168 mm; FOV 396 × 290 mm; 0.097 mm/px.
Lighting targets5000 K; CRI ≥ 90; R9 ≥ 50; ≥ 50 klux; min/max ≥ 0.70.
Strobe targets≤ 5 ms; duty ≤ 10%; ΔE00 ≤ 0.5; flat-field and ColorChecker.
Robot reference7R, OpenArm v2.0; DAMIAO; shoulder–elbow 220 mm; elbow–wrist 141 mm.
ControlIO/PLC; hold the door open while occupied by the robot. Validate cell safety before use.
UnvalidatedPayload, repeatability, cycle time, minimum defect size, recall/precision and false-alarm rate.

Spatial resolution in mm/px is not a defect-detection threshold. Evaluate performance on actual materials, defect sizes, speeds and imaging conditions.

Safety requires assessment of the actual cell, emergency stops, energy isolation, guarding, door risks and power-loss behaviour. PL/SIL safety functions have not been validated.

Sources: landing-page content brief R0, 19 October 2026; light booth dossier and DAMIAO robot design direction R0, 8 October 2026. Values are quoted from the brief and do not replace review of the engineering dossier.

← Back to AI footwear inspection